Merlin II Automatic High Voltage Control,
MSA7006 Control Board.
Calibration of the analog circuits of the
control normally starts showing signs of drift after four to five years of
operation. This drift may be accelerated with higher operating
Insuring operation of the control within
this drift window, the control should be calibrated every two to three
years. Under severe conditions, operating temperatures consistently above
120E F , calibration is recommended every one
to two years.
The calibration may be performed on site,
or the boards may be returned for calibration.
FMDK Technologies Inc provide calibration
services traceable to the National Bureau of Standards. This service is
available on site.
FMDK Technologies Inc. Repair, Parts and
Merlin services are the only OEM authorized (BELCO) facility. The
procedures and bench service fixtures have been purchased by FMDK and are
all from the Merlin original equipment supply, testing and certification.